Home / Services / Data cabling & networking
Cat5e through Cat7, fibre and coax runs, racks and patch panels, Wi-Fi and VoIP — installed to standard, tested end to end, and labelled so the next person can work on it. Residential, commercial and new-build pre-wiring across Ontario.
Structured cabling is the part of a building nobody sees and everybody depends on. Done badly it causes faults you\'ll chase for years.
\nEthernet runs sized to what the link actually needs. We\'ll tell you when Cat6 is plenty and spending on Cat6A buys you nothing at that distance.
\nSingle and multimode fibre where distance rules out copper, or between buildings on the same site.
\nTV, satellite and legacy camera runs, terminated and tested rather than pushed through a wall and hoped for.
\nWall and floor racks, patch panels, cable management and labelling — so the next person can work on it without guessing.
\nNetwork hardware installed and configured, with access points placed by coverage rather than convenience.
\nCable run before the drywall goes on, so adding cameras, an office or an access point later doesn\'t mean opening finished walls.
\nLarger jobs are a different discipline: volume, scheduling around other trades, and documentation that survives after we leave.
\nAnyone can push cable through a wall and crimp an end on it. The test is what tells you it will still work in five years.
\nCorrect pair twist maintained right up to the punch-down. Untwisting too much at the termination is the single most common cause of links that pass at first and fail under load.
Each run is tested end to end, not sampled. A cable that mostly works is worse than one that plainly doesn\'t, because the fault surfaces intermittently.
Runs are verified against the distance limit and checked for the interference problems that cause packet loss rather than an outright dead link.
Both ends labelled, ports recorded. You get the schedule, so you aren\'t dependent on us to work on your own building.
We show the link live before we close up, rather than asking you to take our word for it.
Most Wi-Fi complaints aren\'t a hardware problem — they\'re a placement problem, and no amount of new equipment fixes a badly positioned access point.
\nPositioned for coverage across the whole property, including the garage, basement and yard, rather than wherever the cable happened to end.
\nAccess points fed by cable, not repeating each other. Mesh repeating halves throughput at every hop.
\nHandsets installed and cabled, with the network configured so voice quality holds up when the connection is busy.
\nSeparate networks so visitor devices can\'t reach your cameras, recorders or office machines.
\nKeeping the camera system on its own segment, which protects both bandwidth and security.
\nSlow links, dropouts and dead ports on cabling somebody else installed. Often it\'s one bad termination.
\nFor most homes and small offices Cat6 is genuinely enough — it handles 10 Gigabit at the distances found in a typical building. Cat6A earns its extra cost on long runs, in high-interference environments, or where you're wiring a building you expect to hold for fifteen-plus years. We'll tell you which applies to your run rather than defaulting to the expensive answer.
Usually yes. We fish cable through existing cavities, use basements and attics as routes, and where a wall does have to be opened we keep it to a small patchable hole. We'll walk the route with you before starting and tell you honestly where a visible run or a bit of trunking is the sensible trade-off.
It's cabling installed as a planned system rather than as individual runs added over time: everything terminated to a central rack or panel, labelled at both ends, and documented. It costs a little more up front and saves enormously the first time something needs changing or diagnosing.
Often not. Most coverage problems come from access point placement, not equipment. A single well-positioned access point with a wired connection back to the router usually beats three mesh units repeating each other, because every mesh hop halves throughput. We'd rather run one cable than sell you three boxes.
Yes, and it's much the cheapest time to do it. Cable run before drywall costs a fraction of retrofitting later. We put in runs for cameras, access points, TV points and office positions, and terminate them once the walls are closed.
Yes — office fit-outs, warehouses and multi-tenant buildings. That includes containment, rack build, patch panel termination, labelling and a port schedule. We're used to working phased or out-of-hours where a site can't stop.
Yes, and it's a regular part of our work. Slow links, intermittent dropouts and dead ports usually trace back to one bad termination or a run over the distance limit. We test to find the actual fault rather than replacing everything and hoping.
Yes — handsets, cabling and the network configuration behind them. The cabling and the phone system are the same job in practice, which is why voice quality problems so often turn out to be network problems.
Free assessment, written quote, and honest advice on what you do and don't need.
